GIFT CARD HOLDER
By Kath Steward

Fiskars® Tools
Personal Surecut Paper Trimmer (9893)
Universal Purpose Scissors (9853)
Everywhere Window Punch™ - Frame (5567)
Continuous Stamping Wheel™ (5568)
Continuous Stamps – Dragonfly (5705)
Continuous Ink –Chocolate (5579)
Squeeze Punch - Scalloped Heart (3777)
Lever Punch – Daisy (5463)
ShapeCutter™ (4806) + Mat (8610)
ShapeTemplate – Tag (5374S)
Eyelet setter (3133) & Mat (8605)

Materials
White Square Card Blank 14.5cm x 14.5cm
Kraft White and Pink Paper
Self Adhesive Gems
White Ric Rac Ribbon
Alphabet Stickers
Double Sided Tape
3D Foam Pads
Brown Ink Pad
Glue Pen

Instructions
Step 1
Cut pink paper slightly smaller than card blank. Ink the edge with brown ink pad. Fix a strip of ric rac ribbon down the left hand side and fix to card with D/S tape.

Step 2
Stamp a white piece of paper using Continuous Stamping Wheel™ and Dragonfly and create a tag large with the ShapeCutter™, Mat and ShapeTemplate™. Punch a hole at the top of the tag with the eyelet setter and fix ric rac ribbon.

Step 3
Create a holder for the tag from kraft paper, making sure it is wide enough that your tag will slide in and out. Using Everywhere Window Punch™, create frame aperture as shown. Wrap ric rac ribbon twice around the holder and fix to card using 3D foam pads, only around the outside edges.
Place tag in holder and decorate with the alphabet stickers.

Step 4

Punch 3 hearts from Kraft paper using Squeeze Punch Scalloped Heart. Ink the edges with the brown ink pad and fix over the ric rac ribbon using 3D foam pads.

Step 5
Punch 6 daisies from white paper using the Lever Punch. Fix as shown using Glue Pen and decorate with self adhesive gems.