FISKARS

Description

Step1

Punch 3 large circles from the pink, mauve and tranparent tracing paper with the X-L Squeeze Punch - Circle. With the L Squeeze Punch - Circle, punch 2 mauve and 1 tranparent circle. With the M Squeeze Punch - Circle, cut 1 circle from the mauve tracing paper. Punch a Baby Carriage from 2 fancy papers (Stargazer and Flowers paper). Glue the punched patterns onto the large pink and mauve circles (front and back) and on the medium-sized mauve circle. Punch 2 Foot from the pink tracing paper and glue them onto the large tranparent circle. Punch a Pacifier on the mauve tracing paper and glue it to the medium-sized transparent circle. Punch a Baby Bottle from the Stargazer paper and glue it to the small round mauve circle.

Step2

To create 3D Hearts, punch 4 hearts from different papers. Make a notch on 2 hearts by cutting from the top to the middle, and on the 2 others by cutting from the base towards the middle. The Superimposed Hearts: punch 2 large hearts from the plain pink paper and two small hearts from the turquoise paper. Glue each small heart to the center of the large ones and then glue the large hearts back-to-back. Perforate the "bibs" from the plain paper, large and extra large and superimpose them. Finally glue a punched foot from the pink tracing paper.

Step3

Using the Shapecutter™ Plus, the Crat mat and the ShapeTemplate - Flowers, cut shapes from the pink tracing paper, glue two punched out hearts from the printed paper to the center of the flower. Cut 3 pairs of butterflies from the mauve, pink and transparent tracing paper with the Shapecutter™ Plus and the ShapeTemplate - Butterfly. Onto each circle, position 3 butterflies and fix them with an eyelet. Place an eyelet at the top and bottom of each design.

Step4

Take two round or flat wooden rods. Make a notch in the middle of them and fit them into one another. Make 4 other notches to the first quarter of the rod. Cut small pieces of scoubidous (about 1 cm long), and double up the gift ribbon so that it has a width of 2 to 3 mm. Cut 2 equal lengths of gift ribbon (about 60 cm) and fasten them to the first notches. Pass the gift ribbon into the cat and with a fine needle, thread a scoubidou, then another and make a knot at the second notches. Make a loop that will hang the mobile by making a knot, and to hide it, thread a scoubidou using the needle. Take a needle threaded with nylon and pass it into the scoubidou. Finnish with a crushed pearl. For the rest of the nylon, thread a crushed pearl then pass the thread into the eyelet of the round design of the baby carriage and stop by tightening the pearl.

Step5

Assembly in the same way for each section of the mobile, a needle threaded with gift ribbon, a scoubidou, a design, a space (about 4 cm) then another scoubidou, a design etc. Assembly of a 3D heart: Vertically affix a small piece of double-faced adhesive tape to the center of the hearts and glue the gift ribbon above.

Comments