Comments: 0 Description
Material: metallic Wire (22 gauges) or textile DMC Desire thread, beads, ribbon
Tools: Wire Winder System ( 1364)
Step 1
Take the 4-1 Design sheet, place it on the Wire Winder System and cover with the pegs template and then with the holey plastic sheet.
Step 2
Thread 10 rocaille beads without cutting the thread.
Step 3
Let 3 cm and wind the thread round the 1st peg following the design and pulling the thread to keep it tight. Let slide a bead. Wind the thread round the 2nd peg and let slide a bead…
Step 4
To finish, wind the thread round the 1st and last peg and knot the 2 thread ends.
Step 5
Grasp the plastic sheet and lift carefully off the template.
Step 6
Thread a ribbon in the 1st and last loop to fasten the pendant and finalize the necklace as you want (beads or other embellishments).
Necessary tools
|
