FISKARS

Description

Click on the attached drawing to help and see details...

Step 1

With the Flower Hand punch, punch several flowers on the cone.

Step 2

With the Sunburst Border Punch, cut out a cone on patterned vellum paper (use drawing template). Punch out the border (1 to 5) starting with border 3 (to get a perfect alignment, reverse the border punch to better make adjustments). 

Tips : Paper should not exceed 130 g/m. to avoid damaging the tool.

Step 3

With the Softgrip MicroTip® Scissors, cut a curve on border 6, making sure that this curve fits to the curve of the cone.

Step 4

Using the Eyelet setter & craft mat, put the punched vellum template on the cone while adjusting the curves, and punch 2 holes (3,2 mm) (refer to image). 

Tips : Place and firmly grasp the purple grip on to the cones, then pull (in a straight alignment - not to the side or at an angle) the grey grip straight up and release. Use a craft mat to prevent damage to your work surfaces. 

Overstretch the spring beyond 5 cm may affect the product’s performance. Place the eyelet into the holes (front of eyelet should be face down on the craft mat), set it while firmly grasp the grey end, pull the purple grip straight up and release.

Comments